[funsec] security tool name?

[Blanchard_Michael at emc.com]

That's a good one to have too, as I use pstools all the time and sometimes the command line switches can get a little hairy.  Good to have a tool that helps with the correct switches to use when.

  I found the one I was looking for, http://rpier.sourceforge.net  I was close with my thought of Raptor, Rapier is close :-)

  thanks All!
    Mike B 


Michael P. Blanchard 
Antivirus / Security Engineer, CISSP, GCIH, CCSA-NGX, MCSE
Office of Information Security & Risk Management 
EMC ² Corporation 
4400 Computer Dr. 
Westboro, MA 01580 
Office: (508)898-7102      
Cell:     (508)958-2780 
Pager:  (877)552-3945 
email:  Blanchard_Michael at EMC.COM 

-----Original Message-----
From: Brian Loe [mailto:knobdy at gmail.com] 
Sent: Monday, September 17, 2007 10:10 AM
To: Blanchard, Michael (InfoSec)
Cc: funsec at linuxbox.org
Subject: Re: [funsec] security tool name?

There's this:
 http://www.dadsproject.com/FePsTools/fepstools.htm

But its a front end for PSTools only, it would seem, and not exactly
what you're looking for.

On 9/16/07, Blanchard_Michael at emc.com <Blanchard_Michael at emc.com> wrote:
>
>
> There was a security tool that was basically a front end for many tools.
> You could put pslist into it, tcpvcon, etc.  We were talking about it here a
> little while back but I can't find the posts about it :-(  You had to supply
> the additional tools it would call to use, but it would run the tools on the
> remote machine.  It's not a sysinternals tool, I thought it was up on
> sourceforge, but can't find any name that rings a bell :-(
>